Directions For Heat Transfer

HEAT PRESS TRANSFER INSTRUCTIONS Note: These recommended time, temperature and pressure settings are for N480-640 heat transfer machines. Settings on other heat presses may vary based on their inconsistencies. 1. Preproduction Please check transfers carefully before applying. With the extra transfer provided, cut transfer into 4 pieces and apply on test material until desired results are achieved. If you are unable to get the desired result, please call us before starting job. Set temperature at 400 degrees for ink transfers .Close machine and press 5 seconds to heat. 2. Preheat Garment for Ink Transfers Place garment on platen and press for 5 seconds or until there is no more steam to remove wrinkles and moisture. Check to be sure there are no obstructions such as buttons, pockets or seams. If there are, raise print area only with Print Perfect pad or mouse pad. Ink Heat Press – Set transfer sheet ink side down & close machine. When machine opens, peel off transfer paper quickly in a smooth even motion when hot. These are Hot Peel transfers! 60 lb. pressure. Rhinestone Heat Press – Pre-heat garment for 5 seconds. Peel off white plastic sheet and dispose of. Place rhinestones down on garment with clear heat resistant smooth plastic on top & close machine. For fine fabrics such as silk, polysilk, and lycra use temp: 325-340F, light pressure (25-35 lbs) 7-10 seconds. For transfer on Heavier Fabrics use temp: 350F light to medium pressure (30-40 lbs) 10-12 seconds. Once the transfer is on remove garment from transfer machine and set aside. Let the rhinestone transfer cool. Peel off plastic when transfer is cold. These are Cold Peel transfers! · Disclaimer – We cannot be held responsible for transfers that do not work with your equipment or are put on improperly. The purchase of heat transfers are non-refundable. Do not attempt to use a household iron.